Abocom RE450 Guía de instalación descargar pdf (Pagina 57)

Imaging Utilities and Options 493

Novell Confidential Manual (99a) 28 October 2003

Restore Mode

Use the Restore mode to retrieve an image from a specified location and put it down on the

computer.

Normally, if the image to be put down is a base image (one created previously by the imaging

engine), all existing partitions except Linux and Compaq configuration partitions are removed

from all local writable devices (such as hard disks and Jaz drives) before the new image is put

down. When the image is put down, the sizes of the original partitions from which the image was

taken are preserved if possible. If there’s insufficient space, the last partition is shrunk to fit unless

this would result in data loss, in which case the imaging engine denies the requested operation. If

there’s extra space left after all partitions in the image have been restored to their original sizes,

that space is left unpartitioned.

If the image to be put down is an add-on image (one produced from an Application object or

created by the Image Explorer (Imgexp.exe) utility), or if it’s a base image and you specify the

apartition:ppartition parameter, none of the existing physical partitions are removed. Instead, the

appropriate partitions are merely updated with the files from the image. The update process does

not remove any existing files or overwrite any existing files of the same names if they are newer.

NOTE: Restoring add-on images over 4 GB in size is not supported by ZfD Workstation Imaging.

The syntax of this mode depends on whether you will retrieve the image from a local device or

from an imaging (proxy) server, as explained in the subsections below:

 “Restore from Local” on page 493

 “Restore from Proxy” on page 494

Restore from Local

Use the Restore from Local mode to retrieve an image from a local device and put it down on the

computer. For more information, see Chapter 44, “Setting Up Disconnected Imaging Operations,”

on page 465.

To use the Restore from Local mode:

1 Enter img to display a menu > select Restore an Image > Local Image. Select Local Linux

File System if the image is stored in the local ZfD Workstation Imaging (Linux) partition, or

select the partition where the image is stored. Type the image path and filename. Specify any

advanced parameters, such as sfileset or apartition:ppartition.

Enter the following:

img restorel[pNumber] filepath [sfileset]

[apartition:ppartition]

Parameter Specifies

restorel[pNumber] The partition number (as displayed by img dump) of the local partition to retrieve the image from. It must

be a primary FAT16 or FAT32 partition. This partition will not be changed by the imaging operation.

If you omit the partition number from this parameter, the image is retrieved from the local ZfD imaging

partition.

filepath The filename of the image to retrieve, including the .zmg extension and the complete path from the root

of the partition.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 77 78

Sin comentarios

Abocom RE450 Guía de instalación Pagina 57